Experiment 1: NeoPixel Ring and Joystick

This project uses a NeoPixel ring and an Arduino Uno to show what direction the joystick is being pressed. Come back later for more details on the setup.

Here is the .ino file to load into the Arduino IDE >> joystick_glow

Check it out!

In addition to the below, you will need jumper wires and a soldering tool to connect them to the NeoPixel ring. Please note: these are not the exact items I’m using, but they will work the same way.


One thought on “Experiment 1: NeoPixel Ring and Joystick

Leave a Reply

Your email address will not be published. Required fields are marked *